新浪彩票

Consulting Hotline: 19979112780
网站首页>新闻中心 Position: Home> News
News Center
Internal Features of Stainless Steel Chimney Factory

The stainless steel chimney lining is a very tight type of stainless steel chimney. The outer shell is made of reinforced concrete, and the inner brick is lined with refractory bricks and thermal insulation bricks. As the capacity of the generator set gradually increases, The chimney is also much taller than in the past, and its diameter has become very large. The fundamental area of the chimney is also much larger than in the past, the depth of the fundamental pit is also greater, and the cost has become higher. So what are the tension characteristics of this stainless steel lined chimney?

Currently, stainless steel plates are used to replace the previous refractory bricks to make chimney linings, because the surface of stainless steel plates is very smooth and quiet, has good decay, and the resistance to smoke is not very large. The diameter may be getting smaller and smaller, the weight of the stainless steel chimney is much smaller, the depth of the foundation pit does not have to be too large, and the cost is reduced a lot, which shows that the advantages of the stainless steel chimney lined are very obvious.

The stainless steel used in the lining stainless steel chimney has good corrosion resistance and intergranular corrosion resistance under high temperature environment, and also has good rigidity. Its use time is much higher than that of refractory brick lining, and at the same time no maintenance is required for a long time. This skill has been widely used. This is the lining of stainless steel chimneys to be reported in this article. Tensions.

a